Title: Diesel generator set installation points to note
Time: 2013/7/11 11:23:10
1, the installation location to be ventilated, the generator should be sufficient air inlet side, diesel outlet end should be good. Vent area should be at least 1.5 times greater than the area of the tank.
2, the installation of the surrounding land should be kept clean, avoid placing near the can produce acidic, alkaline and other corrosive gases and vapors items. Conditional extinguishing device should be configured.
3, for indoor use, you must turn the outdoor exhaust pipes pass, the diameter of the muffler must be ≥ pipe diameter, the access to the pipes of the elbow should not be more than 3, in order to ensure smooth flow of exhaust gas and the tube should be 5-10 degrees downward, to avoid the rain injected; vertically upward if the exhaust pipe when installed, you must install rain cover.
4, the basic use of concrete, the installation shall be measured using the horizontal ruler level degree, and the unit fixed on the basis of the level. Between the unit and the base should be a dedicated shock pad or foot bolts.
5, the unit enclosure must have a reliable protective grounding, on the need for the generator neutral grounding, it must be carried out by professionals neutral grounding and lightning protection device configuration, prohibit the use of mains neutral grounding device directly to ground.
6, the generator and the mains switch must be very reliable way to prevent reverse power transmission. Two-way switch wiring reliability required inspection by the local power supply department approval.
2, the installation of the surrounding land should be kept clean, avoid placing near the can produce acidic, alkaline and other corrosive gases and vapors items. Conditional extinguishing device should be configured.
3, for indoor use, you must turn the outdoor exhaust pipes pass, the diameter of the muffler must be ≥ pipe diameter, the access to the pipes of the elbow should not be more than 3, in order to ensure smooth flow of exhaust gas and the tube should be 5-10 degrees downward, to avoid the rain injected; vertically upward if the exhaust pipe when installed, you must install rain cover.
4, the basic use of concrete, the installation shall be measured using the horizontal ruler level degree, and the unit fixed on the basis of the level. Between the unit and the base should be a dedicated shock pad or foot bolts.
5, the unit enclosure must have a reliable protective grounding, on the need for the generator neutral grounding, it must be carried out by professionals neutral grounding and lightning protection device configuration, prohibit the use of mains neutral grounding device directly to ground.
6, the generator and the mains switch must be very reliable way to prevent reverse power transmission. Two-way switch wiring reliability required inspection by the local power supply department approval.
Next a Article: Diesel generator sets an optional basis